Found this snipit over at RideMonkey. Thanks to MMcG for the information!

The bike pictured is actually a Carver 96er frame, so tire clearance is a little tight - but doable and geometry was dialed in via some adjustmentes to the eccentric bottom bracket.

Per Davis:
Since we use an eccentric BB, we can rotate it to the lower position
to get the correct BB height. We’re using the X Fusion Velvet set at the 120
to 110 range to get a 70 degree head angle.

300 mm BB height and a 42.5″ wheelbase. Seems to handle well with the
standard rake. I may try it with a Fox, just to compare.

We are coming out with a
dedicated, standard BB(not Eccentric) aluminum BumbleBee and KillerBee frame
that will retail at around $350.00. About three months or so.